black anticorrosion below the châssis, below the car to avoid oxidation

Yeh but it was way funnier the way i put it

Ahhh ok...

Thankyou for being able to speak English MUCH better than i can French!!!!

Inside the chassis rails/cavities will be treated with a sealer, probably from the BiltHamber range as i have heard good things...

Inside the arches/under the sills are all stonechipped under the paint the rest will remain as you see it...

And so..... assembly begins...









Quality control was present to keep an eye on things....

Probably the last update until after xmas, so to all the viewers, have a great time ladies and gents, peace+love!! And beer... lots of fucking beer!!!

ohhhh le salo
le traducteur torpillie mon com

it's beautiful

Evening all.....

Just a quicky - been fixing the 307 and diagnosing a gearbox issue on my 172..

However!!!


I unpacked the box of plating and anodising i got done over at peterborough plating - fantastic quality!!:





This meant i could start assembling the front corners.. however the dolly i'd made for the bodyshop was going to foul the wishbones... so, i made a new narrow track 1 for the front and threw that on:







Which, after a bit of dicking around gave me:







Now... all i need to do is locate the fecking AP bolts and i can fit the discs up too!!!

Great Job !!

For wonderful results

Travail de malade. Good Job

Evening all....

The dash has been over to Ireland for some TLC at the hands of DieselDave.. (worth a follow on instagram)

I have to say its a f**king good job!!










And after a bit of wrestling it was in place (still a couple of brackets to attach it to the cage) the dash section of harness was clipped in and it was starting to look like a car again...

Are you keeping the stock heater ? If not, what are you using against mist ?

Amazing job as usual

Stock heater has gone.. i think it will be a heated screen and see how that copes..

If its not enough, the ducting under the dash is still in place so i may look at fitting a small aftermarket water/air heater blower to assist...

So.. a casual 67hours at work this week meant not much time for the car.. but after a sunday morning double time stint i popped down the social club for some tinkering..

Pulled up a rug, mother made me a coffee and i set about the discs:






Resulting in:





I did also fit up the harness shoulder straps according to:




And started fitting the gearshift linkages thru the bulkhead - unfortunately a flat phone battery has limited pics for this update....

More fitting up done...